1. Check cylinder head for cracks and warpage at cylinder head gasket surface. Replace cylinder head if warpage exceeds…
Category: 7.3L Power Stroke
1. Disconnect negative battery cable. If vehicle is equipped with dual batteries, disconnect both negative battery cables. Drain cooling…
1.Install the cylinder head gasket. Using the Cylinder Head Lifting Tool (303-D098, D94T-6000-B) and Heavy Duty Floor Crane (014-00071), with an assistant, lift the…
1. Check cylinder head for cracks and warpage at cylinder head gasket surface. Replace cylinder head if warpage exceeds…
1. Disconnect negative battery cable. If vehicle is equipped with dual batteries, disconnect both negative battery cables. Drain cooling…
1. To install, reverse removal procedure. Using the Spring Gauge (211-034, T74P-3504-Y), adjust the actuator rod length to obtain the…
1. Open the hood. Remove the air charge cooler inlet and outlet ducts from the compressor manifold. Loosen the exhaust…
To install, reverse the removal procedure. The exhaust inlet marmon clamp must be positioned on the exhaust inlet pipe before installing the turbocharger. See Fig.…
For inspection and overhaul procedures, see TURBOCHARGER under OVERHAUL.
NOTE: For exploded view of turbocharger, see Fig. 89. 1. Open the hood. Remove the engine cover located near fuel filter/water separator. Disconnect the charge…