1. Loosen and remove the hydraulic cylinder assembly mounting screws and nuts. 2. Support the hydraulic cylinder assembly with nylon lift strap and hoist, and…

1. Remove the screw (1). 2. Tap out the PTO counter shaft (2). 3. Remove the shift fork (3) and sub shaft assembly (4). 4.…

1. Remove the bearing holder mount screws. 2. Jack up the bearing holder (1) by using the two jack screws then remove the bearing holder…

1. Remove the PTO clutch mounting screw (1). 2. Remove the washer (2), clutch cam (3) and spring (4). (When reassembling)  

1. Remove the hex. head plug (1). 2. Remove the spring (2) and valve poppet (3). (When reassembling) • When replacing the valves, check and…

1. Remove the internal cir-clip (1) both side. 2. Remove the cover (2) and (4). 3. Remove the trunnion (3). (When reassembling) • Apply transmission…

1. Remove the motor swashplate setting hex. head screw (1). 2. Remove the motor cylinder block assembly (3) with a motor shaft (2). 3. Remove…

1. Remove the shaft case mounting screws. 2. Screw down the two M6 screws into the shaft case (1). 3. Take out the shaft case…

IMPORTANT • The KUBOTA does not recommend the readjustment of relief valve. And KUBOTA will recommend the exhaust           with genuine parts.…

1. Remove the hex. head plug (1) and remove the spring (2) and relief valve assembly (3). (When reassembling) • When replacing the valves, check…