KUBOTA – L2501 – ELECTRICAL SYSTEM – CHECKING AND ADJUSTING – LIGHT SWITCHES AND FLASHER UNIT – Hazard Switch Continuity

1. Measure the resistance with ohmmeter across the a terminal and c terminal, and across the d terminal and e terminal.
2. If the measurement is not same as below, the hazard switch or the bulb are faulty.

KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - LIGHT SWITCHES AND FLASHER UNIT - Hazard Switch
1. Remove the meter panel and disconnect the 6P connector from hazard switch (1) after…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - PTO Lever Switch
1. Disconnect the 2P connector (2) from PTO lever safety switch. 2. Connect the circuit…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Seat Switch
1. Remove the seat. 2. Disconnect the seat switch connector (3). 3. Change the sensor…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Glow Plug Continuity
1. Disconnect the lead from the glow plugs. 2. Measure the resistance between the glow…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - LIGHT SWITCHES AND FLASHER UNIT - Remove the Combination Switch
1. Remove the steering wheel and rear bonnet and disconnect 8P connector (2) after turning…

Related Posts

Published by samuel