KUBOTA – L2501 – ELECTRICAL SYSTEM – CHECKING AND ADJUSTING – LIGHT SWITCHES AND FLASHER UNIT – Hazard Switch

1. Remove the meter panel and disconnect the 6P connector from hazard switch (1) after disconnect the battery negative code.
2. Remove the hazard switch (1).
3. Perform the following checking.

KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Seat Switch
1. Remove the seat. 2. Disconnect the seat switch connector (3). 3. Change the sensor…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Alternator
1. Disconnect the 2P connector (3) from alternator (2) after turning the main switch OFF.…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Fuse
1. Check the fuse. 2. If any of the fuses is blown, replace it with…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking Connector Voltage
1. Turn the main switch OFF. Measure the voltage between the terminal B (1) and…
KUBOTA - L2501 - ELECTRICAL SYSTEM - CHECKING AND ADJUSTING - ENGINE STARTING AND STOPPING SYSTEM - Checking OPC Timer
1. Remove the timer. (OPC timer is located behind the panel.) 2. Connect jumper leads…

Related Posts

Published by samuel